Vook DVR User Manual download pdf (Page 10)

CONNECTION AND SETUP

2. CONNECTION AND SETUP

Before the DVR is powered on, make sure you have installed a hard disk and connected

at least one camera. For details, please refer to the following sections.

Note: The DVR is designed to automatically detect the video system of the

connected cameras (NTSC or PAL). To make sure the system detection is

correct, please check if the cameras are connected to the DVR and

power-supplied before the DVR is powered on.

2.1 SATA HDD Installation

A SATA HDD must be installed before the DVR is powered on.

Note: It’s recommended to clear all data in the hard disk when the DVR is

powered on and the date & time are set correctly to ensure the recorded

data are not mixed with other data previously saved in the same hard disk.

For details, please refer to “5.6.4 Clear All HDD Data” at page 27.

 For 16CH & 8CH Models

Step1: Loose the screws on the upper cover and open the upper cover of the DVR.

Note: The DVR cover is made of metal. Please be careful with its edge when you

remove the cover.

Step2: There are two HDD brackets

for this DVR as indicated on

the right picture.

2-1 To install on the first bracket

Remove the bracket, and align

the screw holes of the bracket

with the HDD’s screw holes. Make

sure the PCB side of the HDD is

facing up.

Fasten the HDD to the bracket,

and connect the power connector

and data bus connector to the

HDD. Then, replace the bracket to

DVR.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

No comments

Vook DVR User Manual Page 10