Vook DVR User Manual download pdf (Page 14)

CONNECTION AND SETUP

For DVR PIN configuration, please refer to “APPENDIX 6 PIN

CONFIGURATION” at page 53. For connection details, please check with your

installer.

STEP 5: Set the speed dome camera at the DVR side.

Go to “ADVANCE CONFIG” l “REMOTE” to set the speed dome camera.

a) Select the device to “PTZ”.

b) Set the ID to the value the same as the one set in the speed dome camera.

The default ID of the camera is 000.

c) Select the protocol to “NORMAL”.

d) Set the baud rate to the value the same as the one set in the speed dome

camera. The default baud rate of the camera is 2400.

ADVANCE CONFIG

CA N E R A CH1 CH2

CH3

CH4

CH5

CH6

CH7

CH8

CH9 CH10 CH11 W

DETECTION DEVICE PTZ

ALERT ID 000

NETWORK PROTOCOL NORMAL

SNTP RATE 2400

DISPLAY

RECORD

REMOTE

EXIT

2.3 DVR Power On

This device should be operated only with the type of power source indicated on the

manufacturer’s label. Connect the indicated AC power cord to the power adapter, and

plug into an electrical outlet. The power LED will be on.

Note: Before the DVR is powered on, make sure the cameras are connected and

power-supplied for the detection of the camera video system to be correct.

Note: To ensure that your DVR works constantly and properly, it's recommended

to use an UPS, Uninterruptible Power Supply (Optional), for continuously

operation.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

No comments

Vook DVR User Manual Page 14